bing tracking image
Q & A Icon

Can I Use Inno Wedge 660 Rooftop Cargo Box On Tesla Model 3 Factory Roof Rack Bars

Question:

Couple of questions Would this be a good box for a tesla model 3 from an aerodynamic perspective also would it fit on the factory rails.

0

Expert Reply:

The low profile design of the Inno Wedge 660 Rooftop Cargo Box - 11 cu ft - Gloss Black part # INBRM660BK is great from an aerodynamic perspective. It helps to minimize drag and wind noise because of it's shape. To determine if the box will fit your Tesla roof rack and roof it will take some measuring. The memory mount clamps included with this box fit a maximum cross bar size of 3-1/2 inches wide and 1-3/8 inches tall. As long as your bars do not exceed these measurements or less than a 3/4" tall they clamps will fit nicely.

The other measurement to keep in mind is the hatchback clearance to insure you can open the rear hatch without interference with the box. To make sure of this you will need to measure from the center of the front cross bar to the rear opening of the hatch. That measurement needs to be at least 57" for hatchback clearance. The other important measurement is the cross bar spread. The cross bar spread is the measurement from the center of the front cross bar to the center of the rear cross bar. That measurement needs to be a minimum of 24" and a maximum of 39" for the box to fit properly. Please let me know if this is not the case for you and I can recommend another box.

expert reply by:
0
Heather A

Product Page this Question was Asked From


Q & A Icon

Similar Expert Q&A Pages

See More Q&A Expert Answers >>