Aluminum Scissor Steps and Hand Rail Measurements

Question

Question:

It states that the vertical height measures between 31-39, what is the vertical height? Do I measure from our camper door to the ground straight up & down or is this a measurement that angles from the bottom of the door to the ground? We have an older 70s camper that came with a 3 scissor style step and its too short. You have about a foot to step up into the camper. I am looking for one that gets us closer to the camper opening and is safer to get out of the camper. I also need the handrail that you offer to attach to these, will it work with these stairs ? Thank-you

asked by: Tracy

0

Expert Reply:

You are correct the Aluminum Scissor Steps, 24 inches Wide, 31-39 inches Tall, part # AS24, can be fully extended to 39 inches tall, or can be slightly compressed so that they measure 31 inches tall. You will need to measure from the ground to the bottom of your camper door to see what height you need. We do sell the matching handrail, it is the Aluminum Hand Rail for 4 Step Scissor Stair, item # AHR4 and it is custom fit to these stairs.

expert reply by: Andi

0

Answer 1

If you sever the blue wire leaving the P3 controller part #90195 leaving enough room to reconnect it and test the end of the wire leaving the controller with a circuit tester like part #PTW2993 you should see voltage when you slide the manual…

view full answer...

Answer 2

Not following the manufacturer's instructions to the letter will give them an excuse if something were to happen so while I can't recommend drilling the extra holes to ensure it's safely mounted, it's the only way that the steps will…

view full answer...

Answer 3

Both the Brophy #AS24 and the TorkLift #TLA7804 are easily removed when not in use- and it's actually recommended that you do so. Additionally, they both weigh in around 26-lbs total, so they're easy to move on and off; so they'd both be…

view full answer...

Answer 4

I may have different installation method for you, but there is not an extended bracket made to push the TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear #TLA7843 away from your camper to clear your bumper. It may be possible to have a…

view full answer...

Answer 5

I've attached some dimensions below to help you determine fitment of the Brophy Camper Scissor Steps #AS24 with your truck bed camper. The mounting bracket is 24" long x 1" tall (1-3/8" tall if you include the V-Clamps) so…

view full answer...

Answer 6

That is a good question, and you can leave your current fold-out steps up and in the folded position when installing the mounting bracket of the Brophy Scissor Steps. The reason is, the bracket will be installed just underneath the door so as long as…

view full answer...

Answer 7

It is too small of a space to fit the TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear - 4 Steps - 375lbs - Black Bracket Item #TLA7834 but you can instead mount it to the bumper of your camper like in the attached picture.

view full answer...

Answer 8

The steps are very similar but there are some key differences. The Brophy step #AS25 is not meant for permanent installation on the camper; it is to be used while your vehicle is stationary removed prior to travel. The TorkLift #TLA7506 is intended…

view full answer...

Aluminum Scissor Steps and Hand Rail Measurements

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching