bing tracking image
Q & A Icon

RV Steps Troubleshooting Where Module and Wiring Is Good

Question:

The control module on the steps melted. I replaced the control module and the steps will still not work. Confirmed power to everything. Steps still not working?

0

Expert Reply:

Sounds like the motor is bad then if the module and wiring is good. If the steps you have are the Lippert Tread Lites like part # LC353543 that you referenced the correct replacement motor would then be the # LC183058. If you have something else let me know and I'll see what you'd need.

expert reply by:
0
Jameson C

Question:

I have tested the motor with a jumper wire and works in both directions. When hooked up the brake makes a clicking noise and it will move about an inch. Also the brake will not move from on and off position(currently on position). Can I order just the brake and or does new motor include the brake. The controller was melted so I was certain that was the problem at first. With buying the motor if needed, it would have been cheaper to replace entire step. Please advise. Thank you! Lc353543 treadlite 24inch

0

Expert Reply:

You do need a new motor with the # LC183058 based on what you described. This will take care of the issue and would replace all the remaining bad components that could have been damaged in the short.

expert reply by:
0
Jameson C

Products Referenced in This Question


Product Page this Question was Asked From


Q & A Icon

Similar Expert Q&A Pages

See More Q&A Expert Answers >>