Best Cargo Carrier For Use In Salt Water Environment To Avoid Rusting

Question

Question:

I just got a 2" hitch on my 2020 Dodge Journey and I really need a cargo carrier for when we go to Florida. I am worried because my other carrier was exposed to salt water and it rusted after a year

asked by: Pete

0

Expert Reply:

I can understand your concern with rust in a salt water environment. I recommend the Curt Cargo Carrier for 2" Hitches - Aluminum part # C18113 which is an aluminum cargo carrier that measures 21-1/8" long x 47-11/16" wide x 3-3/4" deep of usable space. Since it is aluminum is also only weighs 25 lbs so it easier to take in and out the hitch. I do recommend to spray the cargo carrier and hitch down with fresh water periodically to further extend the life of the hitch and cargo carrier. I have attached a helpful article on preventing rust for your reference.

I also recommend to use the etrailer Trailer Hitch Receiver Lock - Stainless Steel Flush Design for 2" Hitch Receiver part # e98882 to protect your investment. The lock is stainless steel to prevent the lock from corroding and sticking.

expert reply by: Heather A

0

click to enlarge

Answer 1

Trailer tires and wheels do not typically come balanced from the factory like what you see with standard passenger vehicle tires. This isn't usually needed for trailer tires and most car shops don't have the needed setup to properly balance…

view full answer...

Answer 2

You would need a tire with more weight capacity. Basically you need to take the total weight of the trailer when loaded and ready to tow and divide that number by the amount of tires the trailer has and that's the minimum tire weight capacity…

view full answer...

Answer 3

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 7

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Best Cargo Carrier For Use In Salt Water Environment To Avoid Rusting

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching