How To Install the Optronics LED Combination Trailer Tail Lights TLL160RK
Question:
How to I adjust the trailer mounting bolts so the fixture slides onto the bolts and the fixture stays tight to the trailer? I cant figure out how to set the bolt length so the that happens. THe fixture fits loose to the mounting bolts, and falls off when I cross a rough road.
asked by: Kevin J
Helpful Expert Reply:
In order to install the Optronics LED Combination Trailer Tail Lights part # TLL160RK you will first need to drill holes in the trailer or trailer light mounting bracket that align with the mounting holes on the light. The carriage bolts will then slide into the back of the housing on the light and then through the holes on the trailer/light mounting bracket.The flange nuts will then be used to tighten the light to the trailer/light mounting bracket.
I have attached an installation video on these lights for you below. That said, you need to be careful that the carriage bolts seat correctly inside the housing or else it will be very hard to secure the light without it becoming loose.
Product Page this Question was Asked From
Optronics LED Combination Trailer Tail Lights - Submersible - 40 Diodes - Driver and Passenger Side
- Trailer Lights
- Tail Lights
- License Plate
- Rear Clearance
- Rear Reflector
- Side Marker
- Side Reflector
- Stop/Turn/Tail
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 8L x 3W Inch
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Taillight Solution for Lens Number S2T216AP2
- Article: Trailer Lighting Requirements
- Q&A: How Does LED Lifetime Warranty Work on Optronics LED Combination Trailer Tail Lights
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Changing the Bulb in the Wesbar Tail Light Capsule
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Taillight for Zieman Trailer
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Trailer Taillight and Wiring Kit Recommendation for 1994 Four Winn Boat Trailer
- Q&A: Replacement Tail Lights Needed for Monarch # 5237 Tail Lights
- Q&A: Option For Replacing Dexter Axle 89" HF 72.5 SC 2"x2" Square Axle
- Article: Most Popular Wheel Bearings
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision