What is Best Way to Have Trailer Spindles Installed on Axle

Question

Question:

Im building my own off road trailer being pulled by a utv. I think these spindles will be good. What is the best way to mount these spindles? Can they be drilled through to put a bolt through?

asked by: Christopher S

0

Expert Reply:

Spindles like # TRU94FR need to be installed by a welder/fabricator with the correct equipment for the job. It's a precision install that requires specials jigs so that the wheel alignment is perfect. Contact local welders to you and ask if they can install axle spindles. If they can't they'll definitely know someone who can.

expert reply by: Jameson C

0

Answer 1

Assuming your tires are in good shape without any bulges the easiest way to determine if you have a bent spindle is to take a straight edge that is longer than the tire and lay it across the tire parallel with your trailer frame and then measure the…

view full answer...

Answer 2

For a replacement of the NOK AB1990E grease seal you'll need the Grease Seal #13194.

view full answer...

Answer 3

Yes the bearing kit part #DL21792 is the correct kit for your trailer hub BT-100. This comes with two bearings L44643 like we know fit that hub part number.

view full answer...

Answer 4

You can verify that the 10-19 grease seal included in Bearing Kit #BK2-100 is the correct one for your spindles by taking two measurements. First you want to measure the rear hub bore where the seal is inserted. The seal's outer diameter needs to…

view full answer...

Answer 5

We can help you find the seal you need, but the part number you mentioned does not match anything we offer. Can you get me the inner and outer diameters of the seal? With that I can see what we have that matches.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

What is Best Way to Have Trailer Spindles Installed on Axle

Product Page this Question was Asked From

Continue Researching