Comparing etrailer and Curt Trailer Hitches for 2020 Ford Ranger  

In order to obtain replacement hardware for the Curt Trailer Hitch Receiver part #C13417 which is a fit for a 2022 Ford Ranger you'll simply need to obtain the Replacement Hitch Hardware Kit part #RHK.

There is not any added hardware required to install the Curt hitch that fits your 2022 Ford Ranger, which is the following part number: - Curt Trailer Hitch Receiver #C13417 Installation of the #C13417 on a '22 Ranger just requires removing the…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

Yes, we do. To add a hitch to your 2024 Toyota Grand Highlander, I recommend the Curt Trailer Hitch item #C26VV. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a…

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

The TireMinder i10 TPMS #TM38FR refreshes every 6 seconds. You will get a visual and audible alert when the monitor receives the signal from your tire sensor is either below your pressure or the temperature exceeds the maximum setting.

The Firestone In-Cab Pressure Gauge #F2196 will work with the AirLift systems. If you can tell me the part number of which AirLift kit you have I can try and help you with that system if you'd like.

Normally trailer coupler height is around 17 inches, from the ground to the bottom of the coupler, and most hitch manufacturers design their hitches to work with a ball mount that will end up very close to this measurement. I am including a link to…

Yes, the Redarc Tow Pro Liberty part #RED52VR can install in your 2023 Ford Ranger that has the factory 7-way. It would wire directly to the brake controller install wiring that is present under the dash.

Thanks for reaching out, Randy! It sounds like you're looking for something like the In-Cab Air Pressure Monitoring Gauge #F2196 which is a generic kit that can tie-in on the output side of your tank. Any gauge that comes with an air pressure kit…