Recommended Pintle Hitch for 15,000 lb Capacity  

The mounting holes on the Buyers Products 8 Ton Combination Hitch #33710050 are separated by 1-3/4" vertically (center to center) and 3-3/8" horizontally (center to center). This is a pretty standard pattern for pintle hook mounting…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

You are correct, you should only be getting output when the brake is applied, or the override switch is activated. It sounds like the controller might be bad, but to make sure, you should probably bench test it before tossing it. Use a circuit…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

I had the bolt holes on the Super Titan Forged Pintle Hook Plate for 3" Trailer Hitches #RP38186 measured, and they are actually 5/8". That being said, I suggest going with the Curt Pintle Hook #C48215 to attach to it. This does include 1/2…

While drilling holes in any hitch plate like the Buyers #3371809060A will affect its integrity, I believe I have a solution for you. We do have the Hitch Plate #3371809030B which already has the holes for a Pintle #33710057 which also has a…

The Pintle Hook #C48215 that you referenced does include mounting hardware to attach to a pintle hook plate like the Super Titan Forged Pintle Hook Plate #RP38186 that you referenced. I also pulled these two parts and was able to determine that they…

Most pintle hooks use a standard bolt pattern which is 3-3/8" horizontally center to center and 1-3/4" vertically center to center (see photo). Therefore, the Pintle Hook part #C48231 would be a direct fit and work well for you. It also…

If the trailer hitch has a 3/4" diameter hitch pin hole then that is what you'll need to use when towing with said hitch even when using an adapter such as the Curt Hitch Receiver Reducer Sleeves part #C45408. If you don't have a…

I do not have a cut sheet for Buyers 10-hole pintle hook part #337PH55 but the mounting hole diameter measures 0.812". The bottom mounting holes measure 1.062 inches center to center. From the center of the third mounting hole to the center of…

From our experience the military trailer you have uses a standard lunette ring so a pintle hook like the Curt #C48005 would work fine.