Could Hard Metal Lines of Kodiak Hydraulic Brake Hose # bh-3mfs-2 Bend
Question:
Will the hard line portion bend at all, i don’t need a 90 just enough to get it off of spring shackle bolt. Thanks
asked by: Jared B
0
Expert Reply:
The ends of the Kodiak Hydraulic Brake Hose # bh-3mfs-2 are standard hard brake lines which are designed to be bent. Since it's such a short section of the line you wouldn't be able to bend it very much.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Kodiak Hydraulic Brake Hose - 3/16" Male Fittings w/ Stainless Flares - 1/8" ID - 2'
- Accessories and Parts
- Brake Actuator
- Trailer Brakes
- Disc Brakes
- Hydraulic Drum Brakes
- 2 Feet Long
- Brake Lines
- Flexible Brake Hose
- Brake Line Components
- Kodiak
more information >
Continue Researching
- Q&A: Does Mounting Hardware Come with Replacement Landing Gear Gear Box RVLG-RDBOX
- Article: Trailer Wiring Diagrams
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Replacement Recommendation for Atwood Actuator on a 2014 T@B Little Guy Travel Trailer
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Most Popular Wheel Bearings
- Q&A: Replacing Master Cylinder in Titan Model 10 Actuator on Boat Trailer
- Q&A: Comparing Free Backing and Duo Servo Hydraulic Brake Assemblies
- Q&A: How to Determine Correct Torque Setting for New Disc Brake Setup on Boat Trailer
- Q&A: Torque Spec for Installing 10 inch Brake Assemblies on a Trailer
- Q&A: How to Bleed Electric Over Hydraulic Trailer Brakes
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)