Replacement Wheel Stud for Lippert 3,500 lb Axle  

Torque specs for wheel lug nuts will vary depending on the diameter of the lugs, type of lug nut and the wheel's material. The linked chart details the recommended torque for many combinations. Dexter Hub/Drum #84546UC3 has 1/2-inch studs and…

The magnet should only make contact with the inside of the brake drum when power is applied to the magnet. If it is making contact with the drum all the time, you may have residual power running on the brake wire that is just enough to cause the…

I apologize for any confusion on what the proper torque specs are for 1/2 inch lug nuts on trailer wheels. I attached a picture of a chart to the right that details what the proper torque specs are for a trailer wheels lugs based on lug size, wheel…

90-120 ft lbs of torque is probably about right for your trailer rims. If you check out the lug nut torque chart that I attached you will see that nearly all of the torque specs are that and higher.

What you'll want to do is refer to your instructions for the proper torque specs. For example, the instructions for the 5.2K - 6K Kodiak Disc Brake Kit #K2HR526D call for the brake mounting flange to be welded to the spindle and then the caliper…

My friends at Lippert have identified your axle as being a 3500 lb axle with a hub face to hub face distance of 88 inches and a 68.5 inch center to center spring seat distance. Given that, we do offer an axle that would work for you with a slight…

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

To replace the bearings on a Lippert 3,500 lbs axle you will need the outer bearing item #L44649 inner bearing item #L68149. We do have a kit that has the necessary races, seals, and bearings. It is the Hub Bearing Kit for Lippert, Dexter, and Al-Ko…

I wasn't able to find your specific part number hub but if you have a 5,200 lb hub with a 6 on 5-1/2 inch bolt pattern you are going to need a 1/2 inch drive in stud. If your existing drive in studs are 1-13/16 inches long (measurement B in…

I looked up pictures of your trailer and the most similar option we carry to the fender it has on it would be the #HP99VR which is the Jeep style of fender.

In order to determine if the Trailer Hub Wheel Stud #7-122 will work, you will need some measurements from your current studs. Referring to the the included diagram, you will need to at least have the measurements for A, C, and E. You will want to…

The main difference between a ST205/75-14 size tire like the Contender #AC14R45SM and a ST215/75-14 size tire like the Taskmaster Provider Item #TTWTR21514 is that the larger number is a slightly larger size. The 205 has a section width of 7.99"…