bing tracking image
Q & A Icon

Hitch Pin Holes Will Not Align With the Curt Hitch Extender for 2" Trailer Hitches C45795

Question:

I have the 2 inch hitch extender, the holes wont line-up when it all the way in. Its wobbly! Any suggestions?

0

Expert Reply:

In order for the hitch pin holes to line up on the Curt Hitch Extender for 2" Trailer Hitches part # C45795, the distance from the center of the hitch pin hole to the end of the receiver tube on the vehicle must be no more than 3". If it is then you'd have to go with a different option like the Hitch Extender For 2" Trailer Hitch Receiver 14" Long part # HE12 which will allow for up to 4-1/2".

In regards to being wobbly, that is sort of the nature of adding an extra connection but this can be reduced with a device like the Roadmaster Quiet Hitch for 2" Trailer Hitches part # RM-061.

expert reply by:
0
Conner L

Products Referenced in This Question



Product Page this Question was Asked From


Q & A Icon

Similar Expert Q&A Pages

See More Q&A Expert Answers >>