Dimension Pictures of Timbren Axless Less Kit # ASR35HDS01  

I have a solution for you, but the leaf springs we sell aren't rated for off-road use. That's why you are snapping springs. Off-road conditions are just too rough for trailer springs designed for on-road use. Instead you would want…

The 3500-lb Timbren axle-less suspension kits #ASR3500S06 (regular tires) and #ASR35HDS01 (off-road tires) differ in that the kit for wider off-road tires provides a 2-inch greater distance from the mounting point on the trailer frame to the hub…

Yes, there is a 3,500lb Timbren Axle-Less Trailer Suspension that will allow you to use trailer hubs with a 6 on 5-1/2" bolt pattern but you will need to use the Heavy-Duty version part #ASR35HDS01. This system has larger spindles which will…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

You will need to measure the diameter of the spindles where the seal and bearings ride. Check out the picture I attached that shows where this is. You will need an exact measurement so either a digital or dial caliper will be needed. To pick out the…