Clamp-On Exhaust Tips For 2016 Dodge Charger RT
Question:
I have a 2016 Dodge Charger RT. I am attempting to put on an aftermarket exhaust. I am going to cut my resonators out and make it straight pipe. The Outside diameter of my exhaust pipe is 2.25. What diameter tip should I use
asked by: Matthew L
Expert Reply:
If you're not wanting to weld the tip on, I recommend getting a clamp on like the MagnaFlow 3" Exhaust Tip # MF35208. It's made of stainless steel, and will clamp onto pipes ranging from 2-1/4 to 2-1/2 inches in diameter. The MagnaFlow you're asking about # MF35212 won't fit because the band clamp will not connect the 2-1/4 inch diameter of your exhaust onto the end of the tip properly. If you're not against welding on a tip then get the MagnaFlow 4" Exhaust Tip # MF35126. It's the same tip, but has a 4" diameter opening. I'm a big fan of big tips.
Products Referenced in This Question
MagnaFlow 3" Exhaust Tip - Stainless, Clamp-On for 2-1/4" - 2-1/2" Tailpipe
- Exhaust Tips
- Round
- One Tip
- Clamp On
- 3 Inch Diameter
- Angle Cut
- 12 Inch Long
- 2-1/4 Inch Tailpipe Fit
- 2-1/2 Inch Tailpipe Fit
- Rolled Edge
- MagnaFlow
more information >