Does Rhino Rack J-Style Kayak Carrier part # S510 Fit OEM Mercedes Crossbars  

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Part of the problem you are experiencing is that you are using the Thule Compass in the 2 kayak mode which makes the center support vertical and doesn't allow the kayak to lean at all. With a single kayak carrier like the #S510 that you…

While your 2015 Chevrolet Sonic LTZ with an automatic transmission can be flat towed I would recommend using a Dolly #DM9713045 since you are required to stop and run the engine when towing(see owners manual) for extended periods of times. This dolly…

I went out to our warehouse to take a look at the Rhino-Rack J-Style Kayak Carrier #S510 that you referenced. I measured a length of 6-3/4 inches from the outside edge of the mounting hardware to the point on the inside cradle arm where the height…

Check out the picture I attached that shows all three different ways the mounting hardware for the Dockgrip part #TH895 can be orientated. I would try the setup on the right if it seems like the bars aren't thick enough.

So I found online what Rhino Rack sells as their JB0308 and it's actually a combination of parts that we do sell as part #RRRLKHD, #RB1500B (quantity 2), and fit kit #DK498.

The best option we offer to carry both kayaks and paddle boards but not at the same time is the Thule Compass Kayak and SUP Carrier part #TH890000 because the upright can be folded down to carry up to two paddle boards or one kayak and the upright…

Yes, I spoke to my contact at Rhino Rack and the track of Rhino-Rack Roof Rack System w/ 2 Heavy-Duty Square Crossbars #Y01-120B can be cut to the length you need.