How Does Breakaway Lever of Titan Model 60 Actuator Reset

Question

Question:

I forgot to unhook and pulled the actuator forward can’t get it to release back ?

asked by: BJ

0

Expert Reply:

I've spoken with Titan about resetting their model 60 actuator breakaway levers in the past and they have told me that you have to remove the cover and then carefully remove the spring inside. Then set the lever in the disengaged position and re-insert the spring.

expert reply by: Jameson C

0

Answer 1

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 4

You can convert surge brakes to an electric over hydraulic braking system. To do this, you will need an electric over hydraulic actuator and a brake controller. For an electric over hydraulic actuator, I recommend looking at the Carlisle HydraStar…

view full answer...

Answer 5

I do have an option for you but the coupler on your trailer is very old and we simply don't carry parts for them anymore as they were discontinued by the manufacturer. Therefore, the only option we can offer is a new coupler, the Demco Hydraulic…

view full answer...

Answer 6

Hello Darren. Thanks for reaching out, I can definitely help with this. To convert your 2024 Brinkley Z2900 5th wheel over to disc brakes, you will need a disc brake kit, a brake line kit, and electric over hydraulic actuator, and a breakaway kit for…

view full answer...

Answer 7

First you will need to remove the old hydraulic equipment. Remove the surge coupler or actuator, remove all the lines, and finally remove the brake assemblies. If you have 10 inch diameter hub and drums, you may need to replace those as well. If you…

view full answer...

Answer 8

The Demco Hydraulic Brake Actuator part #DM72VR is a great option to replace an Atwood 82543. That said, it does not come with any sort of reverse lockout feature therefore in order to reverse without the brakes locking up you will either need to add…

view full answer...

Answer 9

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

Answer 10

There really isn't a particular maximum trailer weight that is used to determine when brakes need to be added to both axles of a tandem axle setup. While I do still recommend checking your local laws, I am also not aware of any general laws that…

view full answer...

Answer 11

Your best route is to replace your entire surge brake assembly as Atwood no longer produces any parts for their brake actuators. The Titan Zinc-Plated Brake Actuator #T47457207K is going to be your best replacement available. It is specific to disc…

view full answer...

Answer 12

Atwood is no longer in business, which means replacement parts are unfortunately no longer available for your Atwood 61101 surge brake actuator. The best option available if yours is no longer working is to replace the actuator, which you can do with…

view full answer...

How Does Breakaway Lever of Titan Model 60 Actuator Reset

Product Page this Question was Asked From

Continue Researching