Replacement Rubber Insert Strips for Top Channel of Thule WingBar Evo

Question

Question:

Someone stole my rubber strips from the top of my roof racks and the bottom rubber strips. I am looking to replace them. The part number for the roof rack appears to be 186016 Its a Mitsubishi MY18 Outlander SEL can you assist me? Thank you

asked by: Cristo N

0

Expert Reply:

The Thule # TH186016 is a vehicle specific fit kit for their WingBar Evo roof rack. Assuming that you have the WingBar Evo crossbars, the replacement strip is part # 1500052989 which is sold in a quantity of 2.

expert reply by: Mike L

0

Answer 1

We do have the replacement rubber strips for the Thule WingBar Evo crossbars, and like you said they are in fact different than the AeroBlade. The correct part for your WingBar crossbars is the following: - Replacement QuickAccess Interface Top…

view full answer...

Answer 2

To replace the rubber strips in the top of your 53" Thule WingBar Evo Crossbars #TH711420 you need the Replacement QuickAccess Interface Top T-Track Strip #1500052989. This comes with both sides of the strip, but it is one piece so you will need…

view full answer...

Answer 3

I have a couple of options for you for bolts that are compatible with the T-slots in the Wingbar Evo's but the Rhino Rack item #RR92XB do not fit. Instead you will want one of the following: Replacement Square Head Bolt - 6 mm x 61 mm item…

view full answer...

Answer 4

The Replacement Square Head Bolt #853-2089 that comes is the Thule Xadapt8 AeroBlade and Xsporter Load Bar Adapter #Xadapt8 is the longest M6 square head bolt we carry. This bolt is 61mm long and has threads that measure 1-1/4" long.

view full answer...

Answer 5

The Replacement Square Head Bolt part #853-2089 has M6x1.0 threads so any wingnut for this size will work. We don't have a bunch of universal wing nuts for these t-bolts but your local hardware store should have plenty.

view full answer...

Answer 6

Based on your description of the the Thule ski rack fitting a square crossbar I'm going to assume you have the Thule FlatTop 724 or 725 ski carrier, and if so, there is an adapter that will allow you to mount it to the WingBar T-slot. What you…

view full answer...

Answer 7

Great question! The Replacement QuickAccess T-Slot Track Strip #1500052989 comes with a quantity of 2 separate 59" strips. Given those lengths, it depends on the length of your crossbars you have installed whether they can fit yours with just a…

view full answer...

Answer 8

For the Thule Evo roof rack crossbars we have the top t-track strip part #1500052989 and the lower rubber strip part #TH79VW as well.

view full answer...

Answer 9

The Replacement QuickAccess Interface Top T-Track Strip #1500052989 is only available as a pair. Unfortunately, Thule won't sell a single strip so this is the only option.

view full answer...

Answer 10

Yes Yakima roof racks can fit the Thule roof rack tracks. To do that you will need 4 of the Yakima Control Towers #Y8890027, 2 sets of the Yakima Landing Pad #Y00221, and one set of Yakima Crossbars. For 58 inch bars you can use #Y00409, for 66 in…

view full answer...

Answer 11

It sounds like you have a 2019 Hyundai Santa Fe with flush side rails. If that is the case then you will have to install both Thule Crossbars and Thule Mounting Feet as Thule Crossbars cannot be used with Yakima Mounting Feet and the Yakima Mounting…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Replacement Rubber Insert Strips for Top Channel of Thule WingBar Evo

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching