Recommended Trailer Wiring Harness for 2013 Lexus RX 350

Question

Question:

Im looking for the electrical setup for a trailer for a 2013 Lexus RX350, base model that does NOT have a factory installed tow package. Thank you

asked by: James M

0

Expert Reply:

It sounds like you're looking for the 4 way trailer plug for your 2013 Lexus RX 350; I recommend using the Tekonsha # 118255 because we've found that the powered converters on the Tekonsha harnesses are some of the most reliable available. This kit will tee into your tail lights and provide you with a 4 way flat to tow a trailer with and this is compatible with your 2013 RX 350 without the factory towing package.

If you also need a ball mount, hitch ball and hitch pin you can get that all in a complete package with the etrailer Ball Mount Kit # EBMK4. This package has a ball mount that can be used as a 2-3/4" rise of 4" drop, a hitch ball with both 1-7/8" and 2" balls that can be interchanged, plus a hitch pin, clip and storage bag.

I've linked some review videos of these parts for you to check out.

expert reply by: Erik B

0

Answer 1

What you described is a classic insufficient trailer ground. What you will need to do is run a jumper wire from the ground wire on the trailer connector (7:00 pin on the 7-way) to the trailer frame and the intermittent issue will go away. What is…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Hey Gerry, The Stealth Hitches Hidden Rack Receiver #391LXRX16 unfortunately is not a compatible fit for F-Sport models. The only option we currently have confirmed to fit your model would be the Draw-Tite Max-Frame Trailer Hitch Receiver #75540.…

view full answer...

Answer 4

Hi Michael, To replace your Suburban SW6 DE water heater you'll want the Furrion RV Tankless Water Heater #FR98SR. This tankless water heater is one of the most efficient units on the market, producing up 144 gallons of hot water per hour. The…

view full answer...

Answer 5

I'm assuming that you're needing to know so you can choose the correct wiring harness, correct? You could call your Lexus dealer and give them your VIN, and they should be able to tell you how your RX350 is equipped. Or, you could remove the…

view full answer...

Answer 6

The Curt Trailer Hitch Receiver #C73DR you were looking at is a confirmed fit for your 2021 Lexus RX 350 and will fit with your rear lift gate sensor though it will likely change the location your foot must be to activate the sensor. You will need to…

view full answer...

Answer 7

I have a solution for you but the Curt Trailer Hitch Receiver item #13445 does not fit the 2021 Lexus RX 450h. The only hitch available for the 2021 RX 450h is the Curt Hitch Receiver item #C73DR. This hitch is custom fit and bolts directly to your…

view full answer...

Answer 8

When installing the Curt Trailer Hitch Receiver #C73DR on your 2021 Lexus RX 350 while there is no drilling required for installation, underbody panel(s) and/or fascia must be temporarily loosened or removed. Trimming a portion of the lower fascia…

view full answer...

Answer 9

Though the best way to verify 100 percent if your 2012 Lexus RX 350 is to place a quick call to your Lexus dealer with your VIN, you can also look under the bumper to the left (driver's side) and see if you have a panel that can be removed where…

view full answer...

Recommended Trailer Wiring Harness for 2013 Lexus RX 350

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching