Recommended 1200lb Marine Trailer Jack With Snap-Ring Mount  

Not every one of the weld on tubes like what comes with the part #FTJ120W0301 are the same size. However, if you like this jack it would still be your best option to go with it. We do not sell this jack with out the mounting plate so you would want…

The correct replacement for the Fulton Magnum Series Trailer Jack on your trailer is the Fulton Bolt-Thru Swivel Marine Jack part #FXP10W0301 if you have a bolt-thru mounting bracket or part #FTJ120W0301 if you have a snap-ring mounting bracket. I…

Jack #DL22210 isn't a snap ring jack but we do have other options that will likely work with your existing mount such as #FTJ120W0301. The hole spacing for the pull pin is 3 inches apart on center. I have linked a video review of this jack for…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

Thanks for the information and photo, Kenneth! It looks like your trailer is equipped with 3,500 lb axles so to replace your bearings and seals you need the kit #BK2-100, but it also looks like you have an older disc brake kit with a design that…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

Yes, the DeeMaxx Disc Brake Kit #DE66YR will allow you to use 14" trailer wheels.

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…