Recommended RV Entry Step That Can Have Steps Added As Needed  

If your TorkLift GlowStep Revolution Scissor Steps have a 27-1/2' wide mounting bracket then the correct Add-A-Step for TorkLift GlowStep Revolution Scissor Steps is part #TLA8001 which is 22" wide. If your TorkLift GlowStep Revolution…

I have a solution for you but we don't have a replacement bracket to replace the support and bolt that was broken on your TorkLift GlowStep similar to the #TLA8004 . Instead you would need to use the Add-A-Step for TorkLift GlowStep Revolution…

You can indeed add a 5th step later down the line to the TorkLift GlowStep Revolution Scissor Step Assembly #TLA8104 that you referenced. To do this, you will just need the TorkLift Add-A-Step #TLA8101. This will give you a 5th step with the same…

If your step is 25-7/16 inches wide you could use the add-a-step part #TLA8101 as a replacement solution, or if you had a step that was 27-7/16 inches you could use the part #TLA8001.

We don't have an install picture but what I can do is describe it. The portion of the #LC301704 with the round holes mounts to the bottom of the frame on your trailer with nuts and bolts or welding. They would need to be spaced at the width of…

Outriggers such as #LC301704 bolt to the sides of steps such as #LC432698. The outriggers will bolt to the RV frame. For hardware to attach the steps to the outriggers use #LC118155-72. The specific location and orientation of the outriggers depends…

We do carry adapters #LC301704, but with yours new steps sitting further out you might have some issues with the crossbeam of the step hitting the current mounting brackets. If you wanted to make it work you could cut of the older brackets and use…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…