Can Safety Cables be Used Instead of Safety Chains on Trailer  

Yes, you could use the coiled safety cables #RM-643 in place of safety chains when towing your trailer. Just make sure that the trailer is under the 6,000 pound capacity of the cables.

The manufacturers do not typically provide the static weight limit of the roof racks. A lot of that reasoning is that the static load limit is typically higher than the cars roof capacity. What I can tell you is that the Malone AirFlow2 Roof Rack…

Both the Rhino-Rack Vortex Aero and Thule WingBar roof rack systems have very nice features and would work well for your 2014 Hyundai Santa Fe. Both systems are designed to work on vehicles that have the flush mounted rail system. As far as the…

Entry door locks, like the Bauer Products #BA64FR, typically will have a sticker on the inner handle portion that sits inside your RV, but I have installed a few where they also have the key code on a sticker on the inner components of the handle.…

Yes, the Demco Kar Kaddy replacement wheel lug nut part #DM02933 does fit your Kar Kaddy SS tow dolly.

It does look like the D-ring/Tow Recovery hooks on the Rugged Ridge Arcus Front Bumper connect directly to the frame of your 2020 Jeep Gladiator, which is required in order to be able to flat tow with the D-rings, so you're well equipped with…

We have what you need. I will list them below for you. The Blue Ox Aftermarket Off-Road Bumper Adapter - 7/8" Pin #BX88357 for your 1 inch D-rings. The etrailer SD Non-Binding Tow Bar for Blue Ox Base Plates - RV Mount - 2" Hitch - 6,000…

The Bulldog Powered-Drive Kit part #BD1824180100 is for two speed jacks whereas the Bulldog Powered-Drive Kit part #BD1824200100 is for single speed jacks. However, we can only confirm that these work with Bulldog jacks that have a 12,000 lb support…

I apologize for the confusion. It sounds like you have found some conflicting answers in the past, so I took the liberty to contact Bulldog directly and this is what they said: "The 12k RAM jack has a smaller diameter cross-shaft, therefore the…

I went out to the warehouse and pulled a set of Curt Single Hook, Coiled Safety Cables #C80151 to measure the size of the eye opening for you. The width at the widest point is 0.65 inches (between 5/8 and 11/16 inches). And at the longest the opening…

Yes you could use a long enough and correct diameter nut and bolt to secure the safety chains to your trailer if you wanted or you could use the Buyers Products weld on safety chain retainer #3375471000 that you referenced as well.