Rear Bumper Availability For 1993 Ford F-150 Flare Side  

The Westin Fey SureStep Bumper #21002-92230 is a fit for your 1992 F-150 with standard bed and the same is true for the Surestep Deluxe XLT Rear Bumper #21007-92230. The only difference between these two bumpers is that the step-pad surface on…

Looks like you have an older version of the 21007-92230 that you referenced which fits the following: 1973 - 1991 Chevrolet C/K Series Pickup 1973 - 1991 GMC C/K Series Pickup 1967 - 1983 Ford F-100, F-150, F-250, F-350 Standard Bed models 1992 -…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

The #76001 is not a direct fit for your 1989 Ford Bronco. Instead you will want the Westin Fey Surestep Rear Bumper with Custom Installation Kit - Chrome Plated Steel #21002-95600 which is the same style bumper in the correct fit for your Bronco. We…

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…