Will the Fulton FTJ120W0301 Replace an Atwood 500 Pound Swivel Jack

Question:

I can see some of the answers to questions that would indicate this jack can replaced my Atwood 500lb jack on my boat trailer. Looking at the dimension picture I just wanted to verify one dimension. On the swivel portion in the center is shows 2.5inch I just wanted to verify this is the outer dimension of the welded on part and the inner dimension of the actual jack? Essentially the frictioninch surface diameter.

asked by: Todd B

Expert Reply:

The weld on bracket that is included with the Fulton Swivel Jack # FTJ120W0301 does have an outer diameter of 2 1/2 inches. The bracket that comes welded to the jack is slightly larger to accommodate for the 2 1/2 inch bracket to swivel once installed, however. I you are planning on using the bracket from you previous Atwood jack, you will also want to make sure the holes where the pull lever snaps into is 3 inches from center to center as well.

expert reply by: Lazer S