Recommended Latch Repair Kit for a Dico 17550 Coupler  

We have the Titan version of the coupler you need as Titan Weld-On Coupler part #T1755000 which fits a 3 inch channel and is designed for a 2-5/16 inch hitch ball too.

For a very similar coupler to your existing Dico 17550 model I recommend taking a look at the Titan Weld-On Coupler #T1755000. This weld-on coupler is designed for 3 inch wide trailer tongues and has a weight capacity of 21,000 pounds. I have…

Yes, you will be able to remove the master cylinder from the Titan Brake Actuator - Painted - Drum - 2-5/16" Ball - Weld On - 12,500 lbs, part #T1607500. This is a direct replacement, so you will not need a reducer. The master cylinder you…

Disc brakes stop harder than drum brakes and require less maintenance. You will need to make sure the brakes all match if you are adding to the second axle. Also you will need to make sure you have the correct actuator. If you have drum brakes on…

Yes, for just the inner slide assembly of the Titan Model 10 actuator part #T1607500 you would want the part #T1608400317.

I do carry replacement parts for the Dutton-Lainson Sidewind Swivel Trailer Jack, part #DL22800 that you have referenced. The replacement handle is the Dutton-Lainson Replacement Handle, part #DL22448 and the bushings for the handle you will need…

On the Titan trailer coupler #T1755000 the inside is 4-1/4 inches long at the bottom and 3-7/8 inches long at the top. I have included a picture showing these measurements for you.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…