Distance from Pin Hole Center to End of Bar on Reese Weight Distribution Shank RP63971
Question:
What distance is the hitch pin hole to the end of the hitch ? I currently have the 63970 shank and I cannot use the 1500lbs hole because the shank is touching the spare tire mounted behind the receiver on my Kia Borrego 2009.
asked by: Daniel C
1
Helpful Expert Reply:
I pulled one of the # RP63971 weight distribution shanks from our warehouse to measure, and the distance from the center of the pin hole to the rear edge of the shank is 4 inches. I am including a picture showing the measurements I took while I had the shank available.
click to enlarge
click to enlarge
helpful expert reply by: Sarah L
1
Product Page this Question was Asked From
Pro Series Weight Distribution Shank - 14" Long - 4-3/4" or 6-1/2" Drop - 1.5K TW
- Accessories and Parts
- Weight Distribution Hitch
- Shanks
- 1500 lbs TW
- 15000 lbs GTW
- Fits 2 Inch Hitch
- Trunnion - 4-3/4 In Drop
- Round - 6-1/2 In Drop
- Pro Series
more information >
Similar Expert Q&A Pages
- Can Weight Distribution Shank be Used Like a Regular Ball Mount
- Will Reese Weight Distribution Shank # RP63971 Provide 6-Inches of Drop to Keep Trailer Level
- 6 Inch Drop Weight Distribution Shank Recommendation for a Pro Series WD System
- Replacement Weight Distribution Shank for 2-Inch and 2-1/2-Inch WD Systems
- Distance From Hitch Pin Hole to Curve in Shank on Reese Weight Distribution Shank # RP63971
- Recommended Weight Distribution Drop Shank For 63970 Pro Series System
- Recommended Replacement Shank for Use with Reese Weight Distribution Hitch
- Availability of Drop Weight Distribution Shank with 2 More Inches Drop than Reese 54917
- Excessive Trailer Sway Towing 32-Foot Travel Trailer with 6-Inch-Lifted Ram 2500 with 37-Inch Tires
- Shank Recommendation with 2 More Inches of Drop Than RP54970
- Will The Reese Weight Distribution Shank Allow Low Enough Drop And Level Truck and Trailer
- Weight Distribution Shank to Allow Additional Drop with Reese Weight Distribution System
- Longer Weight Distribution Shank to Tow with Tail Gate Down
- More Drop for Pro Series Weight Distribution System on 2008 Yukon Denali
- Minimum and Maximum Height for Trunion Bar Weight Distribution Head Installation on Reese Shank
- Can Reese RP54917 Weight Distribution Shank Be Used in Rise Position
- Can A WDS Shank Be Used Upside Down For More Rise?
- Can Reese Drop Only Shank # RP63971 Be Used with Husky Round Bar Weight Distribution Hitch
- Shank for Pro Series Weight Distribution Hitch to Tow Level
- Weight Distribution Shank with 2 Inch Drop for a Pro Series Weight Distribution System
- Weight Distribution Shank Compatibility With Pro Series Weight Distribution System
- Recommended Weight Distribution Shank With 4 or 5 Inches Of Drop
- Will a Pro Series Weight Distribution Shank # RP63971 Replace a RP54970
- Will The Reese Pro Series WD Shank Work With A Reese WDS?
- Can Pro Series Weight Distribution Shank be Used with a Reese Strait-Line Weight Distribution System
- Weight Distribution Shank with More Drop for Pro Series System # PS49901
- Would the Reese Weight Distribution Shank Part # RP63971 Work for 5 inches of Drop
- Solution to Get Additional Drop from Pro Series Weight Distribution System