Do You Have a Weld On # 84 Spindle With a Grease Zerk For E-Z Lube Hubs?  

Hey Jon, so the Bearing Buddy seal kit part #BB60002 that you referenced is the correct fit based on your bearing numbers.

We carry the Bearing Buddy Spindle Grease Seal Set #BB60002 instead of the Dexter sleeve. I do not recommend the Dexter as with the one hole if that sleeve were to spin on the shaft it would block the hole of the EZ lube grease zerk. With the Bearing…

Based on the information I could find for the DICO 45264 is was popular on ShoreLand'r trailers. This would require the Idler Hub #AKIHUB-545-35-G-EZ-K with the Grease Seal #168255TB used instead of the seal included with the hub. We currently do…

I have three spindles that are for a 3,500-lb axle and have the bearing dimensions you have listed. The only difference is the dimension for the grease seal is 1.75 inches, not the 1.795 inches that you have mentioned. Maybe you typed in the seal…

No, they're welded. You assumed correctly. The spindles listed below that I referenced in your previous question all have to be welded on. There are no thread on spindles. #84 Spindle for 3,500-lb Trailer Axles - 2" Diameter item #TRU24FR…

A trailer that is over 80 inches wide is required by DOT regulations to have rear clearance lights. An over 80 inch taillight kit, like part #TL16RK, will have the side clearance light built into it. An under 80 inch taillight does not have the…

If you check out the diagram I attached you'll see how the O-ring of the Bearing Buddy Grease Seal set part #BB60002 installs. It's location is designed to compress between the seal ring and grease seal to help prevent the seal from leaking…

We do have the etrailer Easy Grease Trailer Idler Hub Assembly #AKIHUB-545-35-G-EZ-K and Trailer Idler Hub Assembly #AKIHUB-545-35-G-K available in a galvanized finish. Currently the Dexter 8-248 Idler Hub #84545BX we only carry in the black finish.…

The nut on the spindle should be tightened until snug, with no side-to-side play in the hub and then backed off slightly, about maybe a 1/8 of a turn. If the spindle uses a castle nut and cotter pin or tang nut, tighten the nut finger tight until it…

There is not a torque spec on the axle nut for the Dexter Trailer Idler Hub Assembly for 3,500-lb Axles - 5 on 4-1/2 #84545BX. The axle will have a castle nut that should be tightened until there is no side to side play and then backed off to the…

After you've packed the bearings and assembled everything, carefully slide the hub assembly onto the spindle and install the outer bearing. Install the spindle and tang washer and run the spindle nut down finger tight, then rotate the hub back…

There is no specific torque rating for the castle nut that holds your hub in place. We recommend tightening the castle nut down until it stops, and then backing it off to the next notch wheel the tang washer will fit into the castle nut. Over…