bing tracking image
Q & A Icon

Reestablishing Connection to Lippert Ground Control After Clearing Function Disabled Error

Question:

I get the function disabled when trying to raise the king pin to previous hitch height. Jameson explained how to hook up, but not how to re-establish the function.

0

Expert Reply:

At the end of the instructions mentioned you are supposed to turn the pad off. You would you just turn it back on and you'd be ready to go.

"In order to hook back up to the truck, they will need to go into manual mode. Once in manual mode, press retract and then press and hold rear to retract the rears. Once the rears are fully retracted, they can press retract again, now system is in extend mode. Then they can press and hold front to raise high enough to back truck under. Then they back the truck under, press retract again and then press and hold front to lower the front. Once trailer is hooked to the truck, press and hold front to finish retracting the front jacks the rest of the way. Then they will turn the pad off and they are good to go."

expert reply by:
0
Jameson C

Product Page this Question was Asked From


Q & A Icon

Similar Expert Q&A Pages

See More Q&A Expert Answers >>