What is the Bolt Pattern for the Buyers Products PH50 Pintle Hook?  

I went to our warehouse and measured the Buyers Products 50 Ton Air Compensated Pintle Hook #337PH50 to get the height dimensions. The overall height of the pintle when open is 12" and when closed is 9-1/2". I also took a measurement for…

Most pintle hooks use a standard bolt pattern which is 3-3/8" horizontally center to center and 1-3/4" vertically center to center (see photo). Therefore, the Pintle Hook part #C48231 would be a direct fit and work well for you. It also…

The Buyers Products 50 Ton Air Compensated Pintle Hook part #337PH50 measures 2.38" deep by 3" wide. The inner eye diameter is 1.60" wide and 1.37" tall. I contacted Buyers and this hook uses a standard Lunette ring.

Curt does not have a minimum plate thickness that they recommend for the #C48231 to ensure its full capacity, instead they recommend attaching it to a surface that is also rated for as much capacity as needed. So, if the bumper/plate is rated for 60k…

It's really just a different bolt hole setup for either. The #337PH50 has 6 bolts and the larger #337PH55 has a 10 bolt setup. This gives a little more flexibility in how it can mount but overall either will do just as good of a job as the…

The bolt holes from left to right on the Buyers Products Pintle Hitch Plate Mount part #337PH50 are separated by 5 inches and from the top to middle the distance is 2-3/8 inch and then from middle to bottom is 2-1/8 inch.

The Buyers Products 45 Ton Pintle Hook #337PH45 has a unique bolt pattern unlike others. I do agree the Clip #3370070055 does not seem sufficient, but the handle is spring loaded so the likely hood of it opening on its own would be next to impossible…

Your 2018 Chevrolet LCF 5500 XD is based on the Izuzu platform. It is not pre-wired for a brake controller. You will have to hard wire the brake controller in this instance. You will need to add a 4-way connector like the ZCI Circuit Protected…

I went out to our warehouse and measured the Buyers Products 45 Ton Pintle Hook #337PH45 for you. The mounting platform where the holes are drilled, has a thickness of 0.7 inches.

The mounting holes on the #337PH55AC have a 0.812" diameter.

I think the best option we have for you is a universal weld-on hitch plate like one of the following that I have attached for you. We do not really have any direct fit hitch plates for you so I think this will be the best option we can offer. If you…