Replacement Pigtail Propane Harness for Coleman Clipper
Question:
Hi, I need to replace this 1/2 inch propane connector for my 2002 Coleman clipper. Any advice?
asked by: Josh
0
Expert Reply:
Looks like you have a longer pigtail harness you are needing a replacement for like the part # 100575-36-MBS which appears to have the same connections on both ends and is at 36 inches.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
MB Sturgis Propane Pigtail w/ Back Check - Type 1 x 1/4" Male Inverted Flare - 3'
- Propane Fittings
- Hoses
- Pigtail Hoses
- 3 Feet Long
- Type 1 - Female
- 1/4 Inch - MIF
- MB Sturgis
more information >
Continue Researching
- Q&A: 12 x 2 Inch Electric Trailer Brakes with a 4 Bolt Mounting Pattern
- Q&A: What is the Four Bolt Brake Mounting Flange for 8,000 Lb Axles
- Q&A: How to Lock-Out your Sidewinder Pin Box
- Q&A: How do You Install a Rhino-Rack Heavy-Duty Bar Roof Rack for Camper Shells?
- Q&A: Recommended Replacement for Atwood GC10A-4E RV Water Heater
- Q&A: White Ceiling Garnish Trim 10-20211 for MaxxFan 6200K
- Q&A: What Curt Q20 Legs are Compatible w/2016 Chevrolet Silverado 2500 6-1/2 Foot Bed w/Factory Rail Kit
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: 2 Steps for Hooking Up an External Propane Tank to Your RV
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: 2023 Best Gifts for RVers & Campers
- Article: How (and Where) to Connect an RV Propane Grill