Correct Replacement for TDE 46210 Trailer Hub  

We have just what you are looking for. I called my contact at TDE and asked about the hub you have on your boat trailer. They told me that it was a 5-stud idler hub for a 3,500-lb axle. That means you need the part #AKIHUB-545-35-K. This is a fit…

The TDE 46210 is going to be same as a typical 3,500lb hub with 5 on 4-1/2" bolt pattern. We have a few options for this depending on what you are looking for and if your axle has the easy grease fitting on the end of the spindle. Standard…

I did some looking and found that the 46210 and 46845 hubs you currently have use the same #L68149 inner bearing and #L44649 outer bearing. However, as we do not carry the Tie Down Engineering Vortex hubs, I cannot say what all will fit them,…

Jeff, I believe that is an older TDE hub which would mean that the Trailer Idler Hub Assembly for 3,500-lb Axles #AKIHUB-545-35-K is the correct replacement.

The Trailer Idler Hub Assembly part #AKIHUB-545-35-G-K or part #AKIHUB-545-35-G-EZ-K for easy grease will be a direct replacement for the TDE 46210. That said, you may also need the Double Lip Seal part #168255TB since that hub can use two…

Thanks for reaching out, Doran! The toggle switch for your FIC-ETJ3500 is pretty unique and it looks like for a direct replacement you'll need to reach out to FIC Jack Services directly at 1-877-957-1501. You might consider looking at and…

It appears TMW is a overseas company which I could not find much information. The 46210 is a common hub number for a 3,500lb idler hub with 5 on 4-1/2" bolt pattern. This would use either the Idler Hub #AKIHUB-545-35-G-K for standard spindles or…

Based on my research the hub 46210 is an idler hub for a 3500-lb axle. Since I do not know which hub bolt pattern you need I have linked our main page that displays all hubs for 3500-lb axles. You need to match up your wheel bolt pattern (please…

In order to choose the correct replacement hubs for a trailer you'll need to know the axle capacity. The make and model of the trailer is usually irreverent as we don't have any way to look up part numbers from this. The axle capacity can be…

I looked up the information on your TDE 46205 Hubs and found a couple of great replacements for you. The one you pick will depend on the number of wheel studs you have. For 5 wheel studs use the etrailer Trailer Idler Hub Assembly for 2,000-lb E-Z…

The Replacement Converter #PD4655V is the correct converter for your Parallax 7355 power center. I do not see that WFCO shows their 8955PEC being acceptable to use with your Parallax 7355.

If you're replacing the controller for your air conditioner system then you'd have to replace the whole distribution box as well because they wouldn't all mount the same and no two brands have been tested to fit together yet. The last…