Dexter Electric Brakes For 6,000 lb Axle  

I'll need to know the inner and outer wheel bearing reference numbers and wheel bolt pattern. With that information, I can recommend replacement bearings, seals, brake assemblies and hub/drums. You'll also want to carefully examine the…

The only difference between the Dexter Electric Trailer Brake Kit part #23-105-106 and Dexter Electric Trailer Brake Kit part #23-105-106-09 is fit. The former works on Dexter or Lippert axles with a five bolt bracket mounting flange whereas the…

A 12 inch, 6-lug hub is going to be a 6,000 lb axle, so the correct electric brakes are the following, and you can choose from manual adjust or self-adjust (Nev-R-Adjust) brakes: - Dexter Electric Trailer Brake Kit - 12" - Left and Right Hand…

We do carry electric trailer brake assemblies with an integrated parking brake for 5,200 lb axles, the Dexter Electric Trailer Brake Kit w/ Parking Brakes part #23-112-113. We also carry the standard version without parking brake, the Dexter Electric…

The center hole of the brake assemblies #23-105-09 and #23-106-09 measures 3-3/16 inches across. The kit for both of these is the part #23-105-106-09 that you referenced.

We do have all the parts you will need but they are not available as a complete kit. First you will need to decide if you would like to install the Dexter Electric Trailer Brake Kit #23-105-106 that includes left and right brake assemblies for one…

You are 99% of the way there! The Trailer Hub and Drum Assembly #AKHD-655-6-EZ-K is the correct replacement for your 8-201 Dexter Axle Hub/Drum Assemblies #8-201-9UC3-EZ with the exception of the grease seal that comes with it. The Dexter Axle option…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Actually, the P3 now has the upgraded axis accelerometer like the P2. The Tekonsha P3 Trailer Brake Controller #90195, will work with both electric over hydraulic brakes on the trailer as well as electric brakes. It has a menu option on the display…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…