Can I Use the Quick Splice Connectors to Install a New Wishbone 4-Flat Trailer Harness  

Hey Jason, Really good questions and we can definitely address them. The tow package on your 2018 Ford Edge only gives the 4-way and there isn't a different option for the 7-way. So because you already have the 4-way with the tow package, the…

You will need to start with a 4-way (if you do not have one). For that you would want the #118677. So the easiest to install brake controller that also works really well is the Curt Echo Mobile part #C51180. Basically this just plugs into an active…

There isn't a quick-install brake controller port on a 2018 Ford Edge Titanium with a tow package for installing a brake controller. In fact the only brake controller we offer that can fit the versions of the 2018 Ford Edge Titanium with the tow…

You are correct, the Curt T-Connector Vehicle Wiring Harness #C56272 is not a fit for a 2019 Ford Edge; this harness is only a fit for 2015-2018 Ford Edge SE and SEL models; whoever told you it did fit your vehicle was mistaken. We carry the correct…

You will need to start with a 4-way (if you do not have one). For that you would want the #118669. I attached an install video that shows this installed in a very similar 2016 Ford Edge as yours. Now if your trailer does not have brakes all you would…

Yes, you can jump the front axles brake output circuit to power the rear axle. Check out the picture I attached to see how most people do this.

The gauge of the wiring in the 4-way kit part #A35W42B is 18 gauge.

On the Wishbone 4-Way Trailer Wiring Harness #A35W42B each wire is 20 gauge. It doesn't seem like much but it is more than enough for basic trailer light functions (stop, tail, turn, and running lights). I have linked a video featuring this…

The TruRyde spindle part #TRU37FR that you referenced is designed for 5,200 lb axles. That capacity of axle has a diameter of 3 inches externally. Spindles aren't designed to just slip into an axle as a replacement. To replace a spindle, the old…

Since your axle diameter is 3 inch that would mean that your axle capacity is between 5.2k and 7k so for a replacement spindle the EZ Lube Spindle part #TRU37FR would fit and work well. This has a 5 bolt spindle though.

Mobile home axle components are considered one time use and are mainly all non-standard parts which means that if you attempt to replace anything on them you find that nothing fits or matches. If you went with a new spindle like the part #TRU37FR…

For a Dexter EZ Lube Spindle 5,200 lb capacity part #8-201-9UC3-EZ the bearings needed are #25580 and #15123. We have a bearing kit that has these as well plus the races and a new seal #BK3-110.