Part Needed To Add An On-Board Compressor Air Line Along Side A Manual Air Line For Air Lift Springs  

The Air Lift LoadLifter part #AL88204 that you referenced does not come with a union tee so that it can be inflated with a single valve so you would need the #AL21838 and you'd be set!

For a union tee to allow you to inflate the bags of the Air Lift kit part #AL88272 you would want the part #AL21838. Price is at the link.

When adding a compressor system like the WirelessONE #AL25980 to your Air Lift LoadLIfter 5000 that feature the braided stainless steel lines you will need to use the included AN to PTC adapter fitting. This fitting will then connect to the nylon air…

The Air Lift LoadLifter 5000 Ultimate Plus kits like the part #AL88288 that come with the braided lines actually also come with the nylon air tubing that runs to the inflation valve still which would be where you'd install a union tee like the…

Since the Air Lift upgrade kits like the part #AL52300 have a portion of the air lines that is plastic still you can use the Tee adapter part #AL21838 on that portion of it.

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

Based on your measurements it matches our Fulton 50-Degree A-Frame Coupler #FE443050303 which looks to be the same as what is on the 2024 Intech Sol Horizon from the videos I could find. So this would use either the EZ Latch #DM14793-81 or…

If you are considering Timbrens like the #TDR1500DQ and the SumoSprings like the #SSR-307-47 for your 2022 Ram 1500 4x4, I recommend the SumoSprings #SSR-307-47. The SumoSprings will offer the same quality as the Timbrens in terms of suspension…

Great question, Kevin. The Onboard Scale system on your 2024 Ford F-350 Super Duty works by essentially measuring how low the bed is sitting and it gives an estimated weight based off of that. If you added a suspension enhancement then that would…

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

Hey Tarek, for your 2023 Ford Raptor I recommend checking out the Timbren Suspension Enhancement System #T75MR. This suspension enhancement system has a load leveling capacity of 3,000 lbs, will increase stability while reducing sag, and will install…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.