Mounting and Depth Dimensions of the Brophy Aluminum Scissor Steps # AS24  

I called my contact at Brophy about the RV Scissor Steps, part #AS24. They told me if you have between 31 and 39 inches of distance from the mounting bracket to the ground, the steps will work well for you. I have attached a photo of the steps with…

The actual weight of the Brophy Camper Scissor Steps - 4 Steps - Aluminum - Non-Slip Tread - 24" Wide - 300 lbs #AS24 is 28 pounds.

The Brophy Camper Scissor Steps #AS24 that you referenced is designed to get removed when travelling. So the bracket would install on the camper under the door permanently and then you'd mount the steps to them when you are parked as needed. To…

I've attached some dimensions below to help you determine fitment of the Brophy Camper Scissor Steps #AS24 with your truck bed camper. The mounting bracket is 24" long x 1" tall (1-3/8" tall if you include the V-Clamps) so…

The Brophy Camper Scissor Steps for truck campers, #AS04, are intended for an entry height of 31" to 40". If your camper door sets within that 31-40' range then yes this will fit your rig. Please see attached image for measuring points…

The TorkLift GlowStep Stow N' Go #TLA7844 weighs just over 30 (about 32) lbs by itself. The TorkLift GlowStep part #TLA7804 and part #TLA7504 both weigh a little over 20 (about 22) lbs each.

The width of the overall step of the #AS24 is 24 inches. I attached a picture that shows the dimensions of the included bracket as well. It is 1 inch tall and is 24 inches in length. You would need compare these dimensions to the area you plan to use…

The scissor step bracket has two L shaped pins on the inside of the angle iron. Measure the center to center distance between the two pins. You will want to drill two 7/16 inch holes into the tailgate that are the same distance apart as the pins that…

When installing the Brophy Tailgate Scissor Step Mounting Bracket #TSSB you will first measure the distance between the two pins on the bracket, on center. Then with your tailgate open and laying flat, you will take a 5/8 inch measurement in from the…

The mounting bracket on the Brophy Aluminum Scissor Steps, part #AS24, is 25 inches long and 1-1/2 inches wide and should be placed 1/8 inch below the lowest part of the door on your RV for installation. The steps I have that are made to bolt or weld…

Not following the manufacturer's instructions to the letter will give them an excuse if something were to happen so while I can't recommend drilling the extra holes to ensure it's safely mounted, it's the only way that the steps will…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.