Is Drilling Necessary to Install Draw-Tite Class I Receiver # 24796 on 2011 Nissan Altima
Question:
Is drilling required for installation?
asked by: Rita
0
Expert Reply:
To install the Draw-Tite Class I receiver, part # 24796 on your 2011 Altima Sedan, you will need to drill a hole through the bottom of the trunk pan using a 7/16" bit.
I have linked you to an FAQ article that contains several hitch install tips. I also added a video of this hitch being installed on a 2013 Nissan Altima.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Hitch Comparison and Recommendation for a 2015 Nissan Altima
- Q&A: Replacement Grease Seal for a 168255TC Rubber Coated Seal
- Q&A: Comparing Draw-Tite and Curt Trailer Hitches for a 2013 Nissan Altima Sedan
- Q&A: Recommended Hitch for a 2024 Nissan Altima
- Q&A: Compatibility of Curt Euro-Style Ball Mount w/ Draw-Tite Class I 24796 on 2010 Nissan Maxima
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Recommended Trailer Hitch And Platform Bike Carrier For 2015 Nissan Altima
- Q&A: Will CURT Trailer Hitch # C11132 Fit a 2008 Chrysler PT Cruiser Convertible
- Article: Trailer Hitch Installation Tips
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best Bike Racks for Electric Bikes
- Article: How to Choose a Hitch-Mounted Bike Rack
- Article: What Do I Need To Tow A Trailer?