Can I Use Counteract Tire Balancing Beads With My RV Tire Pressure Monitoring System

Question

Question:

Hi I have a Coachman Apex travel trailer with 20575R14 tires. I have a TPMS system that has monitoring sensors in place of valve stem caps. Can I use the tire balancing beads system with this type of TPMS? Thanks.

asked by: Craig T

1

Helpful Expert Reply:

Yes, you can use the Counteract Tire Balancing Beads for Tandem Axle Trailers - 4 Tires # CA83VR with any Tire Pressure Monitoring System, TPMS.

The beads will not hinder any readings or cause damage to your devices.

expert reply by: David B

1

Answer 1

Hey Steve, yes the Counteract Tire Balancing Beads for Tandem Axle Trailers #CA93VR will work with your 16 inch tire size. This is a 6 oz size.

view full answer...

Answer 2

Since your trailer has the bracket #FRCBRKT-BL that would mean your trailer has the Furrion pre-wiring which is very common for newer RVs. The part #FOS43TASF is a fit for this and would be a really easy install. This gives you a monitor with a 4.3…

view full answer...

Answer 3

I have linked a picture showing that the Bearing Buddy Bearing Protectors #BB1980A has a full length of 1-3/16" while the part that inserts into the hub is 5/16". This means that the Bearing Buddy will stick out 7/8" from your hub. The…

view full answer...

Answer 4

I checked with Fulton and the U-bolt part #FETC0101 that you referenced has an inner length of 9-1/8 inches and an inner width of 3-5/8 inches.

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

Hey Dan, The info you provided does tell us a bit about the axle but isn't enough to look up what components go with with it. With it being a 3,500lb axle it's probably a generic 3,500lb kit for the bearings and seals but I'd hate to not…

view full answer...

Answer 12

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Can I Use Counteract Tire Balancing Beads With My RV Tire Pressure Monitoring System

Product Page this Question was Asked From

Continue Researching