What Lift Kit Fits My 7,000 Pound Dexter Torflex Axles?  

There is always a way to make it work. I can't recommend doing that as I have not tested it and I do not offer a product like that with the exception of the Dexter Trailer Springs Over-Under Conversion Kit part #K71-384-00. This will give you…

Your leaf springs are already over the axles, so you have a couple of options. You can go with a lift kit or you can replace your axle hangers. The tandem axle lift kit that will work with your trailer is the Lippert Components Tandem Axle Lift…

I sent your axle info to Dexter and they were able to determine that you have a set of 7k Dexter Torflex axles so the correct lift you need is the part #K71-725-02 which will give you a lift of 3-1/8 inches.

There is a solution for you, but the lift kits you referred to such as #K71-725-02 will not work with welded on torsion axles. The best option is for you to simply remove your torsion axles and use the Timbren Axle-Less Trailer Suspension System…

The most common way to lift a trailer is to move the axles below the leaf springs. The diameter of your trailer axle will determine the size of the parts that you will need to order. If your axle is 3 inches diameter, the Dexter Trailer Springs…

According to Dexter this is a 5,200 lb axle. If you were looking for a bearing kit the correct one would be the Bearing Kit, LM67048/25580 Bearings, 10-36 Seal #BK3-300.

I spoke with my rep at Dexter axle and was informed your axle has a 3,500 lbs weight capacity, with a 58" spring center, and a 72" hub face. A comparable replacement is the Dexter Trailer Idler Axle Beam with EZ-Lube Spindles - 72"…

For a 5,200 lb D52 Dexter trailer hub/drum we have the part #8-201-9UC3-EZ which fits your spindle and comes with the bearings and seals. For a set of self adjusting brake assemblies then you'd want the part #AKEBRK-7-SA and you'd be set.

The TruRyde Electric Trailer Brake Kit #TRU96FR that you referenced is a pair of assemblies that include a left and right assembly. So if you need just a left and a right assembly ordering this part number would get you just that.

The P-15 model information you provided for your Dexter axle does indicate its model, but you will still need to note its length and capacity before locating the correct replacement. If you are able to find a longer serial number somewhere on the…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…