bing tracking image
Q & A Icon

Installation of Brake Line on Titan Zinc-Plated Brake Actuator

Question:

On the back of the actuator there is a small brass plug in the end of the master cylinder that has plastic plug in it. When you remove the plastic plug you see a very fine hole in the brass fitting that is in the end of the master cylinder . So do you remove the fitting and just connect hydraulic line directly onto the cylinder or leave the fitting there . This is on a ez loader single axle with hydraulic braking thanks

0

Expert Reply:

When installing the Titan Zinc-Plated Brake Actuator - Drum - Multi-Fit Ball - Bolt On - 7,000 lbs # T43397007K you need to leave the brass fitting that is on the end. This is the orifice connector which ensures proper fluid flow characteristics so it should not be removed or modified in any way.

expert reply by:
0
Robin H

Product Page this Question was Asked From


Q & A Icon

Similar Expert Q&A Pages

See More Q&A Expert Answers >>