Replacement 5th Wheel Landing Gear Foot Pad

Question

Question:

I dont know what size landing gear pad i need for my 2018 Keystone Montana with front kitchen. Can you help?

asked by: Brad C

0

Expert Reply:

It is likely that the Lippert 5th Wheel RV Landing Gear Foot Pad # LC314667 will work for your landing gear. They replace the standard rectangular pad that comes standard with most power landing gear systems. I have included a video that shows how easy the installation of this is. As long as your landing gear has the cotter pin style attachment these should work for you.

If you have an alternative style and can find some markings like the manufacturer and model number or can send in some pictures then I would be happy to help you further.

expert reply by: Scott S

0

Answer 1

To determine if the Lippert 5th Wheel RV Landing Gear Foot Pad #LC314667 will fit on your von weise landing gear I have some measurements you will need to verify are the same with your landing gear. These feet accept a 3/8" hitch pin and the tab…

view full answer...

Answer 2

I reached out to my contact at Andersen and he did say that the red funnel piece on your Ultimate Connection 5th Wheel Hitch #AM3200 is strictly for guidance purpose to ease the hookup process. It has no effect whatsoever as to the actual connection…

view full answer...

Answer 3

Your Keystone Montana is unique in that this is one of the rare trailers that actually has specific landing gear replacements that you will need, and are only available as individual parts (note: the cross shaft is not available as a replacement…

view full answer...

Answer 4

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 12

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Replacement 5th Wheel Landing Gear Foot Pad

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching