Cushioned Weight Distribution 2.5 inch Shank Solution for Ram 2500  

Great question, lets have a look at this unit and see what we can figure out. **Commercial Grade Battery Box for Group 8D Batteries - Vented #329-HM484. *TorkLift PowerArmor Locking Battery Box - 6V and 12V Lithium Batteries - Powder Coated Aluminum…

The Gen-Y Torsion Weight Distribution Shank #325-GH-1102 referenced in your question features 2 different hitch pin holes that can be used. From the center of first hitch pin hole (furthest away from the mounting holes) there is a distance of 13-1/4…

Most weight distribution systems mount on shanks that are 2" wide and have mounting holes that measure 1-1/4" apart on center. I spoke with my contact at Gen-Y Hitch who confirmed that the Torsion Weight Distribution Shank for 2-1/2"…

For a cushioned weight distribution shank that fits the 2-1/2 inch hitch size like what you have you'd want the part #325-GH-1102 which can provide up to 6-1/2 inches of drop. This has the torsion cushioning you are wanting as well.

The key to weight distribution is not to have an exact percentage of the weight transferred to either of the axles. The whole goal behind all of if it is to have your tow vehicle sit as level as possible so that it will brake and handle the best…

If your 251VRK travel trailer's tongue weight is only 630 lbs you would definitely not want a sway control system that is rated for a 1,200 lbs tongue weight. This will you give you a very rigid and stiff ride that would be extremely…

If you have the spring bar tension set up too high you can see ride issues. Typically it's a very harsh ride quality but sway is possible too. The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of…

I do have a recommendation for you to check out, plus I have attached a link to our selection of Weight Distribution (WD) systems that meet the criteria that you specified. As far as ground clearance goes it really just depends on your towing setup.…

For your weight distribution system with sway control, you have arrived at my favorite system for sway control in the Reese Strait-Line. The Strait-Line Weight Distribution w Sway Control - Trunnion Bar #RP66075 is the system you want and it will…

Yes, you could use a 2 inch Weight Distribution (WD) shank like part #RP54970 in place of a 2-1/2 inch WD shank like part #RP54976 as they will have the same 2 inch measurement where the WD head bolts to the shank (see attached picture). You are also…

Since you have a V-nose trailer you'd need bolt on chain hanger brackets on your trailer which we have with the part #RP58305. Once those are installed you could use the Strait Line part #RP66084 which is the correct system for your tongue…

Yes, the Gen-Y Torsion Weight Distribution Shank #325-GH-1102 can be used with a Reese Steadi-Flex weight distribution head like the part #RP66560 that you referenced. The shank dimensions between most systems (including Gen-Y and Reese) are all made…