bing tracking image
Q & A Icon

Picking Out Replacement Landing Gear for Toy Hauler

Question:

Looking to replace the landing gear on my 2005 44ft toy hauler it is a cross terrain

0

Expert Reply:

The easiest way to pick out replacement landing gear sets is to go by the distance between the brackets either on the trailer or on the legs themselves so that you can pick out a set that will match up to the trailer without needing modifications.

Otherwise you could just have the brackets removed from your trailer by a qualified welder and then install the brackets that come with the Bulldog Tandem Landing Gear Set # BD500162. Either way this landing gear set would work well for you, you just might have to have the brackets of your trailer removed and then install the brackets of the # BD500162.

The jacks would be the correct replacement for Lippert, Venture, and Atwood landing gear, as well as those from a few other manufacturers. If you see one of those brands then you know the Bulldog would fit without having to measure. The sure way to tell is that if the distance between the mounting brackets (underside of top bracket to top of lower bracket) is 17-1/2 inches. If this is the case, the landing gear should fit just fine.

If your frame clamps are instead 20-1/4 inches the Ultra Fab part # UF17-943010 would be a direct replacement.

expert reply by:
0
Jameson C

Products Referenced in This Question


Product Page this Question was Asked From


Q & A Icon

Similar Expert Q&A Pages

See More Q&A Expert Answers >>