Availability of a 8" Diameter Trailer Wheel and Tire With Speed Rating Of 81MPH  

For that size tire, 4.80 X 8, I recommend the Kenda tire, #AM10004. This tire has the Load C rating and fits the 8 inch x 3-3/4 inch rim. Using the heavier load range could extend the life of this tire. The Kenda tire is a bias tire that tend to…

The speed rating for the Kenda 4.80/4.00-8 Bias Trailer Tire with 8" Galvanized Wheel #AM30030 is 65 mph.

There is a higher speed rating than 62 mph; the highest speed rating for a 4.80/4.00-8 trailer tire is 65 mph for both the Kenda Loadstar K371 Bias Trailer Tire - 4.80/4.00-8 - Load Range B (590 lbs) #AM10002 and Kenda K371 Bias Trailer Tire -…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

In order to verify the spindle dimensions so that you can pick out the correct hub/drum you have to get exact dimensions. For that you need to use a digital caliper like part #PTW80157. For how old your trailer is this is especially important as the…

The BTR and BT8 denotations refer to the spindle, not the trailer hub. The difference between a BTR and BT8 spindle is that the BTR spindle uses a 1.063" diameter L44649 bearing and the BT8 spindle uses a 0.99" diameter L44643 bearing. In…