bing tracking image
Q & A Icon

Troubleshooting Why Legs Will Not Retract With Error Code Jack Fault Right Rear Jack

Question:

Im get the following error code Jack fault right rear jack. All jacks work fine pressing the buttons. However Im receiving the above error code when using auto leveling. Ive checked the plugs and tried reseting by pressing enter. Any help would be greatly appreciated.

0

Expert Reply:

First you will need to pull the power to the 6-point Set Lippert Ground Control 3.0 Electric Leveling System # LC675817 for at least 15 minutes in effort to reset. Also ensure what your battery bank has a proper charge before doing because the system will be challenged to function without proper voltage. If the error code clears the leg will then move, then reset the zero point.

Below is how to set the Zero Point for leveling:

1. In manual mode, run the jacks to level the trailer. This is best achieved by placing a level in the center of the trailer and leveling it both front to back and then side to side. (See “Basic Jack Operation” for instructions on how to manually operate the system).
2. Once the trailer is level, turn off the touch pad.
3. With the touch pad off, press and release the “FRONT” button five (5) times and then press and release the “REAR” button five (5) times.
4. The touch pad will flash and beep and the display will read “ZERO POINT CALIBRATION ENTER to set, Power to Exit”.
5. To set the current position as the zero point, press the “ENTER” button.
6. LCD display will read “Zero point stability check”.
7. LCD display will read “Zero point set successfully” once process is complete.
8. The system will set this point as its level state and the touch pad will turn off.

expert reply by:
0
Noah E

Products Referenced in This Question


Product Page this Question was Asked From


Q & A Icon

Similar Expert Q&A Pages

See More Q&A Expert Answers >>