Will Diamond LED Tail Lights be Visible at Slight Angle
Question:
I am considering purchase of DG52720PB surface mount lights to replace my incandescent tail lights. The lights would be mounted on a surface that is angled down about 12 degrees from vertical see picture attached. Will this angle adversely affect the visibility of the lights? I ask because I know that some LEDs are somewhat directional. Thank you.
asked by: Bill P
Expert Reply:
Thanks for the photo, and the slight angle will not adversely affect the visibility of the Diamond tail lights you asked about:
- LED Trailer Tail Light w/ Reflector - Stop, Tail, Turn - Weatherproof - 80 Diodes - Red Lens # DG52720PB
These LEDs are not directional, they do light up directly, and are quite bright so they'll be very noticeable. It is definitely a good idea to replace your incandescent lights with LEDs as they last much, much longer and have little power draw.
Product Page this Question was Asked From
Deka Heat Shrink Butt Connector - 16-14 Gauge - Nylon Insulation - Blue - Qty 5
- Wiring
- Wire Connectors
- Butt Connectors
- 16-14 Gauge
- Deka
more information >
Continue Researching
- Q&A: Replacement Propane Gas Detector for an Atwood 31013 Propane Detector
- Q&A: What Gauge Wire Do The Dexter Electric Trailer Brakes 23-47-48 Use?
- Q&A: Best Replacement for Atwood RV Propane Gas Detector 31013
- Q&A: Trailer and Wiring Recommendation for 2024 Kia Sportage
- Q&A: Recommended Replacement for Atwood RV Propane Gas Detector 31013
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Draw-Tite vs. Curt Trailer Hitch For 2023 Kia Sportage
- Q&A: Recommended Hitch for a 2023 Kia Sportage
- Article: My Trailer Hitch Doesn't Fit
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)