Why Would The Wires For My Lippert Ground Control 3.0 Control Module Have Gone Bad?
Question:
Why would the wires in the controller go bad?
asked by: Yvonne
0
Expert Reply:
The wires in your Replacement Control Module for Lippert Ground Control 3.0 Electric Leveling System # LC304136 may have gone bad due damage to the wires, or a short somewhere.
You can use a circuit tester # PTW2993 to test the functionality of the wires from your control module. If the wires are damaged then I recommend replacing the control module with # LC304136.
You might also consider checking the fuses on the control module so ensure they're in proper working order. If the fuses are blown, replace the fuses and check for functionality again.
expert reply by: Bryce D
0
Products Referenced in This Question
Product Page this Question was Asked From
Replacement Control Module for Lippert Ground Control 3.0 Electric Leveling System
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Control Module
- Lippert
more information >
Featured Help Information
Miscellaneous Media
Similar Expert Q&A Pages
- Lippert Ground Control 3.0 Replacement Wiring Harness for Rear Jack
- Troubleshooting Lippert Ground Control that Operates Jack Legs Intermittently
- Troubleshooting Why Legs Will Not Retract With Error Code Jack Fault Right Rear Jack
- Replacement Control Module For Lippert Ground Control 3.0 Leveling System
- What Buttons to Press and Release of Lippert Ground Control 3.0 for Zero Point Reset
- Why Will My Lippert 3.0 Ground Control Not Receive Power on My 2018 Grand Design Fifth Wheel?
- Resetting Lippert Ground Control System
- Replacement Control Module For Lippert Ground Control 3.0 4-Point Leveling System
- Left Side Jack on Ground Control 3.0 Is Not Responding
- Replacement Circuit Board for Lippert Ground Control 4 Point
- Troubleshooting Panel of LCI Leveling System that Has Down Light that Stays on All the Time
- Replacement Fuses for Replacement Control Module for Lippert Ground Control
- How To Clear Lippert Ground Control Leveling System Error
- Purpose of the Antenna on the Control Module # LC304136 for the Lippert Ground Control 3.0
- Troubleshooting Erratic Performance of Lippert Ground Control Leveling System
- Right Rear RR Jack On Lippert Ground Control Only Works In Right Front RF Plug On Control Box
- Troubleshooting Flashing Yellow Lights of Lippert Ground Control
- Setting Up Lippert Ground Control 3.0 After Installing Replacement Control Module
- Troubleshooting Left Side of Lippert Ground Control Leveling System that Doesn't Work
- Troubleshooting LCI Hydraulic Leveler
- Troubleshooting Screen Error Message on LCI Ground Control Electric Leveling System on 5th Wheel
- No Power To Lippert Ground Control 3.0 Control Panel
- Front Jack Legs On Lippert Ground Control Lower When Slide Is Used
- LCI Leveling System Troubleshooting
- Troubleshooting Error Message on Panel for Lippert Ground Control Leveling System
- How Does Lippert Ground Control go Into Manual Mode
- Troubleshooting Error Retract Timeout on LCI RV Levelers
- Troubleshooting Lippert Ultra Level Hydraulic System That Has All Lights On Panel Lit
- One Leg On Lippert Ground Control Not Touching After Screen Shows Successful
- Troubleshooting Flashing Display of Lippert Ground Control and Jacks Won't Retract