Replacement Drain Tubes For Pace Edwards Canister Retractable Tonneau Covers

Question

Question:

The drain tubes on my tonneau cover got damaged. Do you have a replacement for these as I cannot locate the right size tubing.

asked by: Wes S

0

Expert Reply:

Yes, we do have the Replacement Canister Drain Tubes # PE55TJ that is compatible with Pace Edwards retractable hard tonneau covers like the Switchblade # 311-SWC95A17 on your 2019 Chevrolet Silverado 3500.

expert reply by: Bud M

0

Answer 1

There is only one version of the canister drains for Pace Edwards tonneau covers part #PE55TJ and it's this version. If there's a way to secure your loads so that they don't shift as much that would be the best solution we can help with.…

view full answer...

Answer 2

No other brand will not work with the Pace Edwards Retractable Hard Tonneau Cover you will have to use The Replacement Canister Drain Tubes #PE55TJ, the tubes are not interchangeable. The tube installs between the bottom of the canister of your…

view full answer...

Answer 3

We do have the Replacement Tailgate Top Seal #PE99CV, Replacement Sweep Seal Roll #PE78UV and Replacement Bulb Style Tailgate Seal #PE92TJ available like you mentioned. Currently, the "wear" strips are only available in the Replacement Rail…

view full answer...

Answer 4

I spoke with my contact at Yakima who said that they haven't tested a roof rack with a Pace Edwards UltraGroove Metal Hard Tonneau Cover, part #311-KMTA10A38 or #311-KMTA09A37 for a 5' or 6' bed respectively, but he did give me a list of…

view full answer...

Answer 5

The Pace Edwards UltraGroove and Explorer rails are very similar, with the main difference being the height of the rails; UltraGroove sit slightly higher than Explorer rails. While the T-slot channel does differ very slightly (see photo), they are…

view full answer...

Answer 6

I do apologize for your cover not staying closed! There are a couple things that you can do to troubleshoot the latch of the Pace Edwards UltraGroove #311-KRDA24A55. Firstly, make sure that the pull strap needs to be used to close it instead of…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

Hello Kevin, thanks for reaching out. Yakima does confirm the Timberline towers to fit the factory raised rails on the 2025 Honda Pilot. Sadly, they do not offer a direct fit for the LockNLoad Platform so your best option would be to go with a roof…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Replacement Drain Tubes For Pace Edwards Canister Retractable Tonneau Covers

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching