Highest Rated Pintle Hook Plate Mount Hitches for 2022 Ram 5500 Cab and Chassis  

I had the bolt holes on the Super Titan Forged Pintle Hook Plate for 3" Trailer Hitches #RP38186 measured, and they are actually 5/8". That being said, I suggest going with the Curt Pintle Hook #C48215 to attach to it. This does include 1/2…

The standard size for Lunette rings is 3 inch like what you have. While I am not totally certain what hook you have it's likely you did buy the correct size. Due to the looser connections of Pintle/Lunette setups some noise is to be expected.…

The Pintle Hook #C48215 that you referenced does include mounting hardware to attach to a pintle hook plate like the Super Titan Forged Pintle Hook Plate #RP38186 that you referenced. I also pulled these two parts and was able to determine that they…

Most pintle hooks use a standard bolt pattern which is 3-3/8" horizontally center to center and 1-3/4" vertically center to center (see photo). Therefore, the Pintle Hook part #C48231 would be a direct fit and work well for you. It also…

If the trailer hitch has a 3/4" diameter hitch pin hole then that is what you'll need to use when towing with said hitch even when using an adapter such as the Curt Hitch Receiver Reducer Sleeves part #C45408. If you don't have a…

The highest weight rated pintle hitch mount I have that will fit in a 2 inch hitch receiver is the Convert-A-Ball, part #PH2. rated for up to 16,000 pounds. Curt pintle hitch #C48231 does not fit a 2 inch receiver.

The BulletProof Hitches Adjustable 2-Ball Mount for 3" Hitch #58388 that you are interested has a 5/8 inch diameter hitch pin hole which is the standard size for 3 inch hitches. Most likely this is what you have as a 3/4 inch diameter hitch pin…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The standard size lunette ring is 3 inches like the Demco Lunette Ring - Adjustable Channel Mount - 3" Diameter - Black - 25,000 lbs #DM09557-81. The 2-1/2 inch rings will not fit in the adjustable channel mounts where the vast majority of the 3…

The Replacement Inner Slide Channel for Dexter Model 6 #T4846500183 has a shank that measures 3" wide x 2-1/2" tall to it's a little smaller than the 3" square shank that comes on the Replacement Inner Slide for Demco DA91…