Can Spare Wheel/Tire be Carried with 24x84 etrailer Cargo Carrier for RV Bumper  

The 24x84 etrailer Cargo Carrier for RV Bumper part #e96ZR can hold a spare tire but there isn't any sort of specific mount for this. The photo attached below is a custom job from a neighbor and I'm not totally sure what they used to…

The 24x84 etrailer Cargo Carrier for RV Bumper part #e96ZR weighs 82 lbs. Therefore, the bumper must be rated for the weight of the carrier and all cargo, up to 500 lbs. In order to verify the weight capacity of the bumper, you'll need to reach…

The 24x84 etrailer Cargo Carrier for RV Bumper part #e96ZR can be secured in the folded up position. There are two standoff brackets on top of the bumper brackets which will line up with the vertical supports on the side rails of the carrier. They…

The distance between each of the mounting brackets of the 24x84 etrailer Cargo Carrier for RV Bumper #e96ZR is 27-9/16 inches. The picture I attached came from the install instructions which are also linked on this page as well.

The 24x60 etrailer Cargo Carrier for RV Bumper #e99049 and larger 24x84, #e96ZR does not come with a spare tire mounting feature/option. However, if you have enough space on the bumper, you can add a bumper-mounted spare tire carrier next to the…

The carrier in your picture looks like it's welded to the rear bumper so the closest option we would have would be the 24x84 etrailer Cargo Carrier for RV Bumper #e96ZR that you were looking at. This carrier comes with brackets that can fit…

You are correct, you should only be getting output when the brake is applied, or the override switch is activated. It sounds like the controller might be bad, but to make sure, you should probably bench test it before tossing it. Use a circuit…

The correct camper tie-downs for your 2008 Chevrolet 3500 Crew Cab, 8' bed are the HappiJac Truck-Mounted Camper Tie-Downs #LC182905-182971. I was able to verify this using the manufacturers selection guide. This will provide you with the needed…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

For your A-frame trailer the Fulton A-Frame Coupler part #FE443050303 would be an excellent choice. This has more than enough capacity at 10k total trailer weight and uses 2-5/16 inch hitch ball which is a more popular size ball for higher capacity…

Hello Dave. I recommend the DeeMaxx Disc Brake Kit #DE28YR. This uses a corrosion-resistant Maxx coat finish, which is similar to Dacromet or Zinc only better. So not as expensive as stainless, but still good rust resistance. These hubs have a 6 on…