bing tracking image
Q & A Icon

How to Install and Remove LED RV Interior Can Lights with Flat Metal Spring Installation

Question:

To Whom it may concern, Is the mounting spring a wire loop or flat metal spring. If I have too replace the flat metal spring fixture one, how is it done without damaging the thin ceiling board in our 2016 Redwood 5th wheel? As I have already replaced most of the puck lights in our RV as they fail, the original ones having the wire looped spring? I have 17 of these fixtures in our 5th wheel, not counting the smaller ones under and above our kitchen cabinets which have yet to fail.

0

Expert Reply:

The LED RV Interior Can Light # DG52525VP does have the flat metal spring for mounting. For installation, you push the light up into the cutout and the tension on the springs hold the light in place. These are the correct replacements for 4" spring mounted lights.

When removing the flat metal spring lights, you would just need to push the spring in. Typically you can get the light to slide down towards the edge and then reach in with a flat tool to push the spring in, releasing the tension which allows you to remove the light.

expert reply by:
0
Scott S

Product Page this Question was Asked From


Q & A Icon

Similar Expert Q&A Pages

See More Q&A Expert Answers >>