Replacing Obsolete Trailer Spindles With a 1-3/8" Straight Spindle With Current Size Spindles  

There is a 5 lug wheel that has a 4 inch pilot hole opening, the Steel Solid Center Trailer Wheel #AM20053 which is 10 inches in diameter and 6 inches wide with a 5 on 5-1/2 inch bolt pattern; it is a direct replacement for wheels on Tracker boat…

Thank you for providing that information. Based on the fact that you have a #LM67048 outer bearing, #LM67010 race, and measured 1.375" for the ID of the inner bearing it seems like you have a 4,400 lb axle. I would double check that measurement…

I went out to our warehouse and measured an outer bore diameter of 2-1/4 inches on the etrailer.com Trailer Idler Hub Assembly #AKIHUB-545-2-G-2K that you referenced. The reason we don't typically list this dimension on our trailer hubs is…

We will have all the replacement bearing parts you will need as we do not have a bearing kit with all the parts you need. First we have the Bearing #L68149 and its corresponding Race #L68111. It is likely that your spindle will use the Grease Seal…

Yes, the L44649 bearings for a 1-1/6" spindle will have the same outer diameter (1.980") as the L44643 bearings for a 1" spindle so you can obtain the Bearing Kit for 1" BT8 Spindle part #BK1-100 to reuse your hubs.

The reverse light pin on a traditional 7-way trailer connector, like part #PK11893 or a factory connector if that's what you have on your 2018 Ram, is the center pin. Take a look at the picture I attached that shows all the pin functions. To add…

For trailer hub grease seal #168255TB the thickness is 0.5 inches. I included a picture showing the inner and outer diameter and the thickness.

You can check the condition of your hub's races by carefully removing all bearing grease with a rag to expose the actual surface of the races. When they are completely free of grease, etc., inspect them for any signs of scoring (very slight…

I can help you with determining the correct replacement wheel and tires for your trailer with a 6.90-9 tire. Normally you would just need to measure the diameter of the wheel to get the size, but we know a 6.90-9 tire fits a 9" x 4-1/2" or…

I can certainly help you with that. Since the Curt T-Connector Vehicle Wiring Harness, part #C55384 is a 4-way connector the four functions will be Yellow for the left turn and brake, Green is for right turn and brake, Brown is for running lights,…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

In order to verify the spindle dimensions so that you can pick out the correct hub/drum you have to get exact dimensions. For that you need to use a digital caliper like part #PTW80157. For how old your trailer is this is especially important as the…