Replacement Replacement Pitch Arm for Solera Awning  

The correct replacement pitch arm for your LCI Solera XL Awning is part #LC74VR on our site. This is the 78" long arm in black like what you were looking for. Please note that this comes in a quantity of 1 so you'll want to order…

If you have a 78 inch Soler XL awning that has a 20 foot awning installed the part #LC74VR would work but it's not awning length specific.

It sounds like you're a looking for a replacement pitch arm for a Solera Power Awning Assembly. The three most common sizes we offer are the part #LC74VR which measures 78", the part #LC67VR which measures 63", and the part…

For replacement arms that fit in place of your 63" tall Solera awning arms we have the Solera Classic Universal Awning Support Arms for RVs which come both in Black #LC434715 and White #LC434716. If you weren't needing the entire…

The best way to determine the correct replacement pitch arm for a Solera awning would be measuring. The part #LC74VR measures 78", the part #LC67VR measures 63", and the part #LC375994 measures 69". If you have another…

As for the vent replacement, I recommend sticking with the MaxxAir brand and going with the MaxxFan Deluxe Roof Vent w/ 12V Fan, Thermostat, and Remote - Powered Lift - 10 Speed - White #MA00-07000K. The The built-in rain shield on this powered…

We do offer replacement covers for the heads of the Lippert Edge awnings. For the drive head, you'd want the #LC32NJ cover you'd looked at and for the idler head, use part #LC37UD.

Hey so I apologize for the delay on this and also for not being able to really help but I finally heard back from Solera and they said they don't have the dimension and they didn't have any in stock to measure. Also we don't…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

When installing The Replacement Pitch Arm #LC375994 you will need to use three of the retaining washers #LC431583. I attached a review video link below.

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…